Skip to main content
Skip table of contents

Installation

  1. By running the installer, a wizard will help you in the installation of the n-MF Lexmark. It's recommended that, during the installation, you close all other applications.

  2. The wizard will ask you to choose the language of the installer. Choose which one you desire and click OK.

  3. Following, the wizard will opens it's interface, click Install to start the installation process.

  4. Next, it is necessary to set the directory address of where the n-MF Lexmark will be installed at. By default, it's suggested the directory: C:\Program Files\NDDigital\n-Billing\n-MF\Lexmark. After configuring the directory, click Next.

  5. Set up the IP Address of where the n-Host or nddPrint Host is installed on. Type in the IP Address of the server and click Next. If the Host is installed in the same server as the n-MF, this interface won't be shown.

  6. The next interface will exhibit a summary of the installation. In this point it's possible to return and change the settings. If you agreed with the current settings, click Install to proceed with the installation.

  7. Once finished, click "Finish" to close the wizard.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close